Oce VarioPrint 6000 series, User Manual

Page: 51 / 66

51
Clean the OPC belt (left)
Clean the OPC belt
Attention:
Do not touch the OPC belt with your fingers.
1.
Rotate the metal OPC pulley until the spots are visible.
[64]
[64] Rotate the OPC pulley
2.
Apply a small amount of Cleaner P on an offset pad.
3.
Clean the spot with this offset pad.
4.
Carefully remove all Cleaner P from the OPC belt. Use new offset pads for
this.
Lock the OPC unit
1.
Rotate the metal OPC pulley until the end of the back side of the OPC belt
runs near (+/- 0.1 inch) the arrows of the yellow registration board.
[65]
[65] Reposition the OPC belt