9
P O W E R C O N N E C T I O N S
The Obsidian Control Systems NX 2 and NX WING accept AC mains power at 100-240V
50/60Hz. Do not connect it to power outside this range. Damage resulting from incorrect
connection is not covered under warranty.
North America: A cable with a NEMA 15-5P plug is provided for use with the NX 2 and/or NX WING in
the USA and Canada. This approved cable must be used in North America.
Rest of the world: The provided IEC cable is not fitted with a country-specific plug. Install only a plug
that meets local and or national electrical codes and is suitable for the country’s specific requirements.
A 3-prong grounded-type (earthed type) plug must be installed following the plug manufacturer’s
instructions. The table below shows some possible pin identification schemes; if the pins are not clearly
identified, or if you have any doubts about proper installation, consult a qualified electrician.
Wire color (standard EU code)
Pin
Symbol
brown
live
L
blue
neutral
N
yellow/green
ground
To apply power to the product:
1. Set the power switch to the center OFF position.
2. Insert the 4-pin XLR connector from the external power supply unit into the power input on the back
of the console.
3. Insert the provided power cable into the IEC connector of the power supply unit and connect the
cable to a properly protected and grounded outlet.
4. NX WING: Connect the USB cable to the PC system.
5. Turn the console on by toggling the power switch to the CPU position for the NX 2, or the ON position
for the NX WING.
