Operating & Maintaining the Eden 3-D Printer
7–48
DOC-00500 Rev. F
The
waste
container
consists
of
a
plastic
container
inside
a
cardboard
box.
You
typically
dispose
of
the
entire
waste
container—including
the
box.
Therefore,
you
must
assemble
a
new
box
and
insert
a
new
plastic
container
before
you
can
install
it
in
the
printer.
To prepare a new waste container:
1. Assemble
the
cardboard
box,
making
sure
to
punch
out
the
perforated
sections.
2. Place
a
new
plastic
container
into
the
box.
Note:
Do not close the box until you connect the waste drain tube from the
printer (see below).
To replace the waste container:
1. Locate
the
door
on
the
lower
‐
left
side
of
the
Eden
printer.
2. Push
in
the
upper
‐
right
corner
of
the
door
to
release
the
latch
and
open
the
door.
Figure 7-4: Accessing the waste container
3. Carefully
slide
out
the
waste
container,
removing
it
from
the
printer.
Figure 7-5: Removing the waste container
4. Place
the
new
waste
container
next
to
the
full
container.
Replacement boxes, plastic containers, and sealing caps are supplied in the
Eden printer start-up and preventive-maintenance kits.
