Created by Neevia Personal Converter trial version
Objet Geometries Ltd Eden330\333 User Manual
4 - 1
1. Operation and Maintenance
Read all of the following chapters that apply to your particular work.
Do not open the hood while the system is working. Do not bypass the
hood’s interlock.
Do not stare at the UV light. Use protective eye glasses while the UV is ON.
Do not touch the
Model
and/or
Support
material with bare hands. Wear
gloves during cleaning of the
Model
and/or
Support
material from the
machine. If you make skin contact with
Model
and/or
Support
material,
wash the area as soon as possible with water and mild detergent.
1.1 Installation and Training Rules
An authorized Customer Support representative from Objet Geometries Ltd.
will perform the following tasks:
Unpack, install, assemble and completely check the Eden330\333 system
before approving it for operation.
Train the selected personnel to operate the system. Only trained personnel
are qualified to operate the system.
Only an authorized Customer Support representative from
Objet
will be
responsible for the system service and maintenance.
The user must follow all safety rules and regulations as described above.
1.2 Working with the Eden System
Procedure for Starting on the Eden330\333
1. Check that there is sufficient material in the cartridges (see Loading and
Replacing Material Cartridges).
2. Check that there is no printed model on the tray.
3. Perform the Daily Maintenance procedure.
4. Start the EDEN330.EXE program at the Embedded Workstation.
Created by Neevia Personal Converter trial version
http://www.neevia.com
