OBaby zeal, Instructions Manual

Page: 5 / 13

Fitting and Removing the Hood
Adjusting the Hood
fig. 24
fig. 27
fig. 29a
fig. 25
fig. 28
fig. 29b
fig. 26
fig. 29
fig. 29c
To open or close the hood, pull or push the hood as shown above. (fig.27-28).
To open the visor, simply pull out from inside the hood (fig.29)
To extend the hood, first unzip the first section of the hood (fig.29a). Then pull hood
forward and down until fully extended (fig.29b-29c). To close do the reverse.
fig. 30
fig. 33
fig. 31
fig. 34
fig. 32
fig. 35
fig. A
Using the Harness
Press
‘D’ Ring
To fit the hood, place the hood on the chassis, inline with the seat unit. Clip the hood
into each side of the chassis (fig.24). Attach using hook and loop tape around chassis
(fig.25). To remove the hood, press to release the clips (fig.26).
Waist
Strap
Crotch
Strap
Shoulder
Strap
Clasp
Harness
Positions
Lower
Inner
Inner
Outer
Outer
Outer
Upper
To fasten the harness, clip each chest strap onto the waist
strap (fig.30) and insert both fasteners on the waist strap
into the clasp on the crotch strap (fig.31 & 32).
To release the harness, press the centre of harness clasp
(fig.33).
Adjust the harness length using the buckles on each strap
(fig.34).
‘D’ Ring
The ‘D’ rings highlighted are provided for fitting a separate
harness complying with BS 6684 (fig.35).
When using the safety harness from birth, it may be necessary to use the lower holes for
the shoulder strap and the inner holes for the waist straps and crotch strap.
Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap
should be used when your child is of a suitable size. (See fig.A)
WARNING: Always use the crotch strap in combination with
the waist belt
8 9
www.obaby.co.uk
www.obaby.co.uk