OBaby Tour, Instruction Manual

Page: 5 / 7

Fitting and Removing the Hood
Adjusting the Hood
fig. 23
fig. 26
fig. 24
fig. 27
fig. 25
fig. 28
To fold the hood, lift the hood adjusters up on both sides of the hood, as shown above.
fig. 29
fig. 32
fig. 30
fig. 33
fig. 31
fig. 34
fig. A
Using the Harness
Squeeze
‘D’ Ring
To fit the hood, place the hood on the chassis, in line with the seat unit. Clip the hood
catches onto each side of the chassis (fig.23-25).
To remove the hood, do the reverse of the above.
Waist
Strap
Crotch
Strap
Shoulder
Strap
Clasp
Harness
Positions
Lower
Inner
Inner
Outer
Outer
Outer
Upper
To fasten the harness, insert each waist strap fastener
through the loop on each shoulder strap (fig.29). Then
insert both waist strap fasteners into the clasp on the
crotch strap (fig.30 & 31).
To release the harness, squeeze each of each clips in the
centre of the harness and pull away from the clasp, one at
a time (fig.32).
Adjust the harness length using the buckles on each strap
(fig.33).
‘D’ Ring
The ‘D’ rings highlighted are provided for fitting a separate
harness complying with BS 6684 (fig.34).
When using the safety harness from birth, it may be necessary to use the lower holes for
the shoulder strap and the inner holes for the waist straps and crotch strap.
Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap
should be used when your child is of a suitable size. (See fig.A)
WARNING: Always use the crotch strap in combination with
the waist belt
8
9
www.obaby.co.uk
www.obaby.co.uk