Oasis MAXXFILL FLEX, User Manual

Page: 8 / 16

HOT COLD
BOTTLE
POU
WATER SUPPLY
SWITCH
HOT WATER
SWITCH
COLD WATER
SWITCH
8
1. Locate the water supply switch on the back of the unit near the top. Switch the unit to POU.
2. Turn on the water supply to the unit and check for leaks.
IMPORTANT! Make sure both cooling system and hot water switches are off.
INITIAL SET-UP FOR A BOTTLE-LESS SYSTEM
3. Plug the dispenser into a grounded GFCI power outlet. An internal solenoid valve will turn on for several
minutes to fill the cold and hot tanks.
4. Once the solenoid valve has stopped, place a container under the water dispense point and press the
hot water dispense button until water flows freely.
5. Turn ON both the cooling system and hot water switches located on the back of the dispenser. If you are
not going to use hot water, turn the hot water switch OFF to conserve energy.
6. The first time the dispenser is used, you will have to wait at least 1 hour for cold water and 15 minutes for
hot water.
7. Refer to the OPERATION step on page 6.
NOTE: Please allow the several minutes for solenoid valve to operate and fill up the water tanks
before using the dispenser. If the water tanks are not full, water will not dispense.