Oase ProfiLux Garden LED Controller, Operating Instructions Manual

Page: 12 / 116

- EN -
12
Connect the ProfiLux Garden LED Controller to the InScenio FM-Master WLAN EGC
An EGC connection cable is necessary for connection.
• The EGC connection cable is available as an accessory in the lengths 10 m (47040), 5 m (47039) and 2.5 m (47038).
• Ensure the correct connection.
How to proceed:

B, C, D
1. Remove the terminal resistor from the EGC output of the InScenio FM-Master WLAN EGC and keep in a safe place.
2. Fit the plug connector of the EGC connection cable to EGC-OUT on the InScenio FM-Master WLAN EGC and se-
cure.
3. Remove the protection cap from EGC-IN on the ProfiLux Garden LED Controller and fit the other plug connector of
the EGC connection cable.
4. Remove the protection cap from EGC-OUT on the ProfiLux Garden LED Controller and fit the terminal resistor.
Connect additional EGC units
An additional EGC unit can be connected to the ProfiLux Garden LED Controller.
• Ensure the correct connection.
How to proceed:

B, C, D
1. Remove the protection cap from EGC-OUT on the ProfiLux Garden LED Controller and fit the plug connector of the
EGC connection cable.
2. Remove the protection cap from EGC-IN on the additional unit and fit the other plug connector of the EGC connec-
tion cable.
3. Remove the protection cap from EGC-OUT on the additional unit and fit the terminal resistor or connect an addi-
tional EGC unit.
Conn
Connecting the spotlights
A
ProfiLux Garden LED RGB is connected to LAMP-OUT of the ProfiLux Garden LED Controller, starting with LAMP-
OUT 1.
How to proceed:

C, D
1. Remove the protection cap from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
Switching on and off
The device is pre-set on delivery to the demonstration mode "colour change" for the operation of ProfiLux Garden LED
RGB spotlights. This mode remains activated until a different mode is set using the app of the InScenio FM-Master
WLAN EGC. Different colour change sequences or colours can be set for individual spotlights or all spotlights in the
system with the aid of the app.
Switching on
: Connect the power plug of the device to the mains socket.
• Check the function of the spotlights.
Switching off : Disconnect the device power plug.
N O T E
For further information regarding the operation and integration into the EGC system, please refer to the instructions for
use of the FM Master WLAN EGC at http://www.oase-livingwater.com/egc-start .