Oase ProfiClear Premium Compact-L EGC, Operating Instructions Manual

Page: 30 / 46

- EN -
63
5.2.3 Setting the filter pump status detection
Setting is only necessary in the following circumstances:
► The installation height of the filter container differs from the system-specific requirements.
► The admissible frictional resistances in the supply lines differ considerably from those specified.
The filter pump status detection signals via the system message
Er88
if the filter pump is operating
correctly. The system message
Er88
is not triggered unless the status detection is activated for 10 minutes
continuously. This prevents brief fluctuations in the water level from triggering the system message
Er88
.
Check the setting according to the water level in the filter container and correct it if necessary to ensure
that the status detection signals correctly. In addition, the losses in the supply line due to the filter pump
must be at least 3.5 mbar (3.5 cm).
► The status detection can be deactivated if necessary. (→
E7
: Pump status detection)
How to proceed:

S
1. Remove the container cover.
– The filter drum is stopped for safety reasons if the filter cover is lifted and
Er11
is indicated in the
display of the control system.
2. Switch off the filter pump.
3. Switch off the mains voltage (ensure that the control system is isolated).
4. Measure the distance between the top edge of the container and the level of the water and determine
the necessary position of the holder according to the table.
5. If the determined position differs from the current position, correct it as required
– Undo and remove both screws of the holder. Push the holder into the correct position and fasten
with both screws.
6. Fit the container cover.
7. Switch on the control system and filter pumps and check the function of the status detection.
The status detection is correctly set when the float sinks with the filter pump switched on and the system
message
Er88
is only triggered 10 minutes after the filter pump is switched off.

S Water level in the filter container/pond
(measured from the top edge of the container with the filter pump
switched off)
max. min.
159 mm 179 mm 9
152 mm 172 mm 8
145 mm 165 mm 7
138 mm 158 mm 6
131 mm 151 mm 5
124 mm 144 mm 4
117 mm 137 mm 3
110 mm 130 mm
2 1)
103 mm 123 mm 1
1) Factory setting
Downloaded from www.watergardeningdirect.com