Oase PondoVac 5, Operating Instructions Manual

Page: 19 / 208

- EN -
19
Opening/closing the tank
Attention! Dangerous electrical voltage!
Possible consequences: Death or severe injury.
Protective measures: Prior to commencing work, disconnect the unit from the mains.
How to proceed:

C
1. Release the locking clips.
– To do this, grip the clips from underneath and pull upwards.
2. Lift off the vacuum head and the adapter ring.
– The vacuum head and adapter ring can be removed separately.
– The plug connector for the discharge pump does not need to be disconnected.
3. Assemble the parts in the reverse order and fasten with the locking clips.
– Ensure that the parts are precisely aligned in relation to each other.
– Ensure that the seal on the adapter ring is correctly seated so that it is not damaged during assembly.
Assembling the vacuum cleaner
Fitting the wheels
How to proceed:

D
1. Insert the wheel into the wheel bush.
2. Firmly push the wheel until it locks into place.
Fitting the outlet
Prerequisite: The tank is open.
How to proceed:

E
1. Check the correct seating of the adapter with non-return valve.
– Ensure that the adapter is locked into place in the tank wall.
2. Screw the Storz coupling type C onto the outlet and hand-tighten.
Fitting the inlet
Prerequisite: The tank is open.
How to proceed:

F
1. Insert the intake distributor into the opening.
– Guide the pins on the intake distributor through the notches of the opening.
2. Twist the intake distributor to lock it into place (bayonet closure).
– Ensure that the outlet of the intake distributor in the tank is angled downwards.
3. Fit the debris collection bag onto the intake distributor in the tank.
– Ensure that the elastic of the debris collection bag is seated in the groove of the intake distributor.
– Secure the debris collection bag with the Velcro tape.
Downloaded from www.watergardeningdirect.com