10
- GB -
Installation
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:
Prior to reaching into the water, disconnect the power supply to all units used in the water.
Disconnect the power plug prior to carrying out work on the unit.
When installed above the water level, maintain a safety distance of at least 50 cm from combustible material.
Ensure a safe and stable seating. Do not cover the unit. Danger of fire!
Position the unit in such a way that it does not present a hazard to anybody.
Setting up with the ground stake (B)
Fully insert the ground stake (2) into the soil.
Place the unit on the ground stake.
Adjust the tilt of the light (F).
Installation with bolt attachment (C)
Undo and remove bolt (11) and nut (8).
Take out lamp (6).
Wall or floor mounting (D):
Bolt the foot (9) to a firm base or load bearing wall. Use the supplied dowel (10) and
bolt (7). Drill a 5 mm hole at least 35 mm deep.
Mounting to ceiling:
The supplied dowel (10) is not approved for mounting to ceiling and must not be used for this
purpose!
Place the light on the foot and screw tight. Ensure that the nut (8) is in the small hole and the screw (11) with screw
cap (12) is in the large hole of the screw connection (13) and the detent tabs are engaged.
Adjust the tilt of the light (F).
Connection (E)
Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (14)
hand-tight.
To connect the Lunaqua Maxi LED Solo, disconnect the jumper plug (bridging plug) from the transformer and
connect the lamp directly.
Start-up
Attention!
Sensitive electrical components.
Possible consequence:
The unit will be destroyed.
Protective measure:
Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:
Prior to reaching into the water, disconnect the power supply to all units used in the water.
Disconnect the power plug prior to carrying out work on the unit.
Note:
The LED light cannot be dimmed. The brightness of an LED reduces as the operating time increases.
Switching on:
Insert the power plug of the transformer into the socket.
Check the function of the spotlights.
Switching off:
Disconnect the transformer power plug.
Summary of Contents for Lunaqua Maxi LED
Page 1: ...Lunaqua Maxi LED Set 1 Set 3 Solo...
Page 2: ...2...
Page 3: ...3...
Page 24: ...15188 09F...
