6
GB
Operating instructions
GB
Changing the bulb
1. Turn off the light or the safety transformer and ensure that it cannot be
accidentally turned on.
2. Loosen the screws of the upper section.
3. Remove the upper section and the glass and clean if necessary.
4. Remove the bulb from the fitting and replace. Do not touch the glass of the bulb
with your hand.
5. Take note of the power information on the bulb.
6. Check the O-ring and replace it if damaged.
7. Reassemble the parts in reverse order.
Technical data
Lunaqua 10
Voltage
12 V / 50 Hz
Power consumption (in Watts)
35 W / 50 W / 75 W
Spread of light
24°
Malfunction
Lamp does not
light
Luminous
power dropping
Water in
spotlight
Light flickers
Possible cause
Power supply
interrupted
Soiled
Seals
defective
Corroded
contacts
M e a s u r e s
1. Check power supply and fuses.
2. Check lamp, change it if
necessary.
3. Clean contacts, spot light and
transformer
Clean
Check seals ans replace, if
necessary
Clean lamp pins, disconnect
cable hamess from spot light,
clean contacts
Defect and repair
Cleaning
– Carry out the steps as described for changing the bulb.
– Only water and a soft brush should be used.
– Ensure that no moisture enters the spotlight.
Repair
– If the cable or the housing is damaged, the transformer cannot be repaired and
must be replaced.
Lunaqua-10 Exp.p65
17.03.2003, 13:32
6
