5
Unpacking
When unpacking, if external damage is visible which could impair the functioning
of other constituent parts of the equipment, please inform the carrier (haulier,
railway, postal or parcels service) of the defects immediately, on the same day
if possible, and insist on written confirmation. Then contact your supplier who will
take care of everything else.
GB
Operating instructions
GB
List of parts
– Lamp housing (without lamp)
– Swivel bracket
– Nut and fixing bolt
– Ttake
– Instructions for use
Assembly (fig. 1)
– Assemble the swivel bracket (fig. 5)
– Place the nut into the hole in the side.
– Set the swivel bracket in position and gently screw the bolt into the nut.
– Secure the bracket in position using the screws.
– Insert the lamp (fig. 1) (Do not touch lamp with a bare hand)
– Connect the spotlight to the OASE safety transformer using the OASE cable set
(see figs. 2-4).
– Follow the directions for use of the cable set and the safety transformer.
– Position the spotlight so that it is not a danger to anyone.
– Use the swivel bracket and the stake (figs. 6 and 7). The spotlight must be
attached in such a way that cannot be removed without tools (permanent
installation). (The stake must only be used when the lamp ist used our of pond)
– Insert the connector from the safety transformer into the socket.
– Adjust the angle of the spotlight to suit.
Use these instructions to familiarize yourself with the device before you use it for
the first time. It is absolutely essential that you observe the safety guidelines on
the proper and safe use of the device.
For safety reasons, children and young people under 16 years of age, as well as
people who cannot recognize potential hazards or who are not familiar with these
instructions, must not use this device!
Please keep these instructions in a safe place! In the event of a change of
ownership, please pass these instructions on to the new owner along with the
product.
Where can I use Lunaqua 10
– For use in fountains and ponds, both in and out of water.
— Maximum capacity of lamp in water: 75W
– Maximum capacity of lamp in and out of water: 50W
– In installations over water, a safety margin of 50cm must be maintained from
any inflammable material.
– The lamp must not be covered.
Lunaqua-10 Exp.p65
17.03.2003, 13:32
5
