Oase ClearTronic 11 W, Operating Instructions Manual

Page: 8 / 89

- EN -
8 ClearTronic 7 W / 9 W / 11 W
Only allow children to carry out
cleaning and user maintenance un-
der supervision.
Safe operation
•
Dangerous electrical voltage. Possible death or se-
vere injury from electrocution! Prior to starting any
work, switch off and disconnect (isolate) the unit,
and secure it from being switched on again.
• Never operate the unit if either the electrical cables
or the housing are defective!
•
Do not carry or pull the unit by its electrical cable.
•
Route cables/hoses such that they are protected
from damage and do not present a tripping hazard.
• Only open the unit housing or its attendant compo-
nents, when this is explicitly required in the operat-
ing instructions.
• Only carry out work on the unit that is described in
this manual. If problems cannot be overcome,
please contact an authorised customer service point
or, when in doubt, the manufacturer.
•
Only use original spare parts and accessories for the
unit.
• Never carry out technical modifications to the unit.
• Power connection cables cannot be replaced. If a ca-
ble is damaged, dispose of the respective unit or
components.
Electrical connection
• Only connect the unit if the electrical data of the
unit and the power supply coincide. The unit data is
to be found on the unit type plate, on the packaging
or in this manual.
•
Ensure that the unit is fused for a rated fault current
of max. 30 mA by means of a fault current protec-
tion device.
•
Protect the plug connections from moisture.
• Only plug the unit into a correctly fitted socket.
Symbols used in these instructions
C A U T I O N
•
Indicates a possibly hazardous situation.
•
Non-observance may lead to slight or minor inju-
ries.
N O T E
Indicates information intended to give the user a bet-
ter understanding.
Additional information

A Reference to a figure, e.g. Fig. A.
→
Reference to another section.
PRODUCT DESCRIPTION
Scope of delivery

A
1 Casing
2 Unit head
3 Hose nozzle
4 UVC lamp
5 Operating instructions
Function description
The special UVC radiation of the UVC clarifier elimi-
nates floating algae and other algae that give water a
green colour. It also kills bacteria and other germs. The
UVC clarifier is integrated in the water circuit, ideally
upstream of a filter.
Intended use
ClearTronic 7 W / 9 W / 11 W, referred to in the fol-
lowing as "unit", may only be used as specified in the
following:
• For cleaning aquariums.
• Operation under observance of the technical data.
The following restrictions apply to the unit:
•
Only use indoors and outside of the aquarium.
•
Do not use for commercial or industrial purposes.
•
Never use the unit to convey fluids other than wa-
ter.
• Not to be used for sterilising drinking water or other
fluids.
•
Do not use in conjunction with chemicals, foodstuff,
easily flammable or explosive substances.
INSTALLATION AND CONNECTION
Prerequisite
•
The unit head is removed. (→ Dismantling the unit
head)
Set-up the unit
How to proceed:

B
•
Only install the unit in the permitted positions to en-
sure fault-free operation.
• Allow sufficient space for carrying out maintenance
work.
Connect the unit
How to proceed:

C
1. Screw the hose connector with union nut and seal
onto the connection on the casing.
–
Connect the inlet and outlet.
–
Hand-tighten the union nut.
2. Screw the lock nut onto the hose connector, fit the
hose onto the hose connector and turn back the
lock nut to fix the hose in place.
3. On completion of the work, fit the unit head.
(→ Fitting the unit head)