Oase biOrb HALO 15 MCR LED, Operating Instructions Manual

Page: 21 / 168

- EN -
21
How to proceed:

H
1. Carry out further settings with the aid of the remote
control.
Switches on the light.
Switches off the light.
Start of the cycle through the possible light col-
ours.
End of the cycle through the possible light col-
ours.
Switches the LED to the basic colour red (R).
Green (G), blue (B) respectively, or colours
other than these 3 basic colours. 15 predefined
colours.
White light ("Daylight"", W)
Dims the light, 4 brightness stages: 80 % …
20 %. To reset to 100 % press any button for se-
lecting the light colour.
…
Four buttons for setting the daylight and moon-
light phase.
Daylight and moonlight phases
The time for daylight and night light can be changed
using the keys 8 HR, 10 HR, 12 HR or 14 HR. The day-
light is always reduced by 15 min for sunrise and
15 min for sunset. Total duration of a daylight or night
light phase: 24 h.
Time
Mode/button 8
HR
10
HR
12
HR
14
HR
Sunrise Min. 15 15 15 15
Daylight h 7.5 9.5 11.5 13.5
Sunset Min. 15 15 15 15
Night light h 16 14 12 10
MAINTENANCE AND CLEANING
Cleaning and maintenance work:
Area Tasks to be carried out
Lighting unit Clean when required.
Change the battery of the remote
control when necessary.
(→ Changing the battery)
Aquarium water Partially replace every 4 to 6 weeks.
Together with the filter cartridge.
(→ Preparing the water)
Filter cartridge. Replace every 4 to 6 weeks depend-
ing on the number of fish.
(→ Replacing the filter cartridge)
Aerator Replace every 6 months.
(→ Replacing the aerator)
Aerator pump Replace every 12 months if neces-
sary. (→ Installing and connecting
the aerator pump)
Cleaning the lighting unit
Cleaning cloths are available as OASE biOrb “Cleaning
cloths” (46027).
How to proceed:
•
Bottom surface of the lighting unit: Wipe with a spe-
cial cleaning cloth to avoid scratches.
Changing the battery
How to proceed:

I
1. Turn the remote control over and open the battery
compartment.
2. Pull the battery holder completely out and change
the batteries.
–
Pay attention to the polarity of the batteries.
3. Push the battery holder back into the remote con-
trol.
Preparing the water
Filter cartridge, water treatment sachets and a clean-
ing pad are available as OASE biOrb Service Kit (46014).
Prerequisite:
Fresh water has been treated with "Water Condi-
tioner" 24 h beforehand and has reached room tem-
perature. Required quantity: Approx. one third of the
aquarium volume.
How to proceed:

J
1. Remove the water to be replaced and clean the
aquarium with the cleaning pad for acrylic glass if
necessary.
OASE recommends:
•
biOrb cleaner pump (46025)
•
Cleaning pads (46026, only use the rough side for
particularly stubborn deposits).
2. Top up the aquarium with the treated water.