![background image](http://html1.mh-extra.com/html/oase/aquaoxy-500/aquaoxy-500_operating-instructions-manual_3131180012.webp)
12
- GB -
Installation and connection
Installation
B
•
Connect the air hoses to the aeration stone and Y distributor.
•
Connect the Y distributor to the aeration pump with the air hose.
−
Shorten the air hoses to the desired length for the installation.
−
Keep the air hoses as short as possible.
C, D
•
Install the unit in a stable, horizontal and flood-protected position.
−
Install the unit above the level of the water otherwise it will be damaged by water flowing back.
−
Ensure that the unit is installed with a safety distance of at least 2 m from the water.
•
Position the aeration stones in the pond.
−
Lay the air hose/air hoses well protected and without kinks, keeping them as short as possible.
Start-up
Switching on:
Connect the unit to the mains. The unit switches on as soon as the power connection is established.
Switching off:
Disconnect the unit from the mains.
Remedy of faults
Malfunction Cause
Remedy
The unit is not operating
No mains voltage
Check mains voltage
The aeration stones are soiled
Clean or replace the aeration stones
The air filter is soiled
Clean or replace the air filter
Air hose kinked or porous
Lay the air hose without kinks or replace
The unit does not deliver any air or the amount
delivered is insufficient
Membrane is defective
Replace both membranes
The unit is unusually loud
Membrane is defective
Replace both membranes
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences:
Death or severe injury.
Protective measures:
•
Before reaching into the water, disconnect all units located in the water from the mains.
•
Disconnect the unit from the mains before performing any work on the unit.
•
Secure the unit to prevent unintentional switching on.
Opening the housing
E
•
Undo the screws on the bottom section of the housing and remove the top section of the housing together with the
sealing ring from the housing bottom.
Cleaning the air filter
8.
0.
How to proceed:
F
1. Remove the filter holder from the top section of the housing with the aid of a screwdriver.
2. Remove and shake out the filter fleece or replace if necessary.
3. Push the filter fleece into the filter holder.
−
Pay attention to the O ring as it holds the filter holder in the housing.
4. Reassemble the unit in the reverse order.
Summary of Contents for AquaOxy 500
