Oase AquaMax Eco Premium 6000/12 V, Manual

Page: 13 / 136

EN
13
Installation and connection
The pump can be installed submerged (in water) or dry (outside the water).
The use of the pump is only permitted with observance of the specified water quality.
•
Pool water or salt water can impair the appearance of the unit. Such impairments are excluded
from the guarantee.
WARNING
The power supply carries dangerous electrical voltage and must not be placed directly near wa-
ter. Otherwise, there is a risk of serious injury or death from electric shock.
 Install the power supply in a flood-protected position at least 2 m from the water.
CAUTION
Rotating components in the intake and pressure socket area. Risk of injury when reaching into
the sockets.
In particular, observe the following:
A unit that has stopped due to overload can start up unex-
pectedly!
 Do not reach into the opening of the intake socket or pressure socket while the power plug is
plugged in.
 If the sockets are freely accessible during operation, e.g. if no hoses are connected, use a hand
guard to secure the sockets. The hand guard is available as an accessory.

Avoid exposing any unit components to direct sunlight for extended periods of time, as this
can lead to damage. If necessary, use a protective cover.
Submerged installation of the pump
Connecting
Connect the pump according to the desired installation variant. (
→
Installation variants)
 B
•
Ensure that the intake-side hose (IN) does not have a smaller diameter than the pressure-side
hose (OUT).
•
The larger the hose diameter, the smaller the friction losses in the lines and the better the
flow rate.
•
The hose diameter must not be limited unnecessarily by a hose sleeve. Shorten the hose
sleeve based on the hose diameter, if necessary.
Do not plug the power plug into the socket yet!