12
DIRECTIONS FOR USE
To maintain your pedicure sink and its pipeless jets at maximum level of hygiene, thoroughly clean
the tub shell and jets after each use with a nonabrasive antibacterial cleaner, rinse thoroughly and
dry completely. NEVER use abrasive cleaners on any part of the appliance.
DISASSEMBLY & INITIAL CLEANING
a. Turn pedicure sink off by rotating the control button. Drain the foot bath according to drain-
ing procedure.
b. Remove both jet assemblies. To remove each jet assembly from its casing. Rotate the jet
assembly counterclockwise and pull outward.
c. Remove white impeller cap & impeller.
d. Spray the jet assembly pieces, foot bath interior and jet cases with cleaner/disinfectant.
e. Use a clean cloth to clean the jet assembly pieces, removing any visible soil.
f. Scrub all surfaces of the foot bath and jet cases.
g. Rinse all surfaces with tap water.
DISINFECTION & RE-ASSEMBLY
a. Spray the jet assembly pieces, jet cases and foot bath until thoroughly wet with cleaner/
disinfectant and allow then to set for one minute.
b. Rinse disinfectant from all surfaces.
c. Dry the jet assembly pieces, jet cases and the foot bath with a clean cloth.
d. Reassemble jet assemblies and reinsert them into jet cases, rotate them in a clockwise man-
ner to secure them into position.
e. Rotate tabs until they latch, they must be latched for the pumps to work. There are two at 180º
from each other.
RECOMMENDED DISINFECTANTS
The use of an EPA registered cleaner/disinfectant with tuberculocidal, germicidal, pseudomo-
nacidal, Fungicidal and Virucidal efficacy is recommended. Do not use abrasive cleaners on
the Pedicure Basin or Jet Assemblies. *DISPATCH
®
Hospital Cleaner Disinfectant with Bleach
is a suitable cleaner disinfectant for use with the above procedure.
Dispatch
®
- EPA Reg. No. 56392-7; EST. No. 62801-MI-
001.
CLEANING THE FOOT BATH:
