WARNINGS
/
SYMBOLS
15
CARE
&
CLEANING
CARE & CLEANING
UPHOLSTERY
Before cleaning with any
liquid cleaner be sure to un-plug
the power cord from the power
outlet. Do not operate the table
in standing water.
CAUTION
In order to maintain your product’s quality and ensure the life of your upholstery, we
have tested several preventative steps you can take to protect the upholstery fabric on
your table and accessories.
Here are a few suggestions in caring for your upholstery fabric:
• DO NOT store your table or upholstery fabric-covered accessories in temperatures
below 32°F/0°C or above 95°F/35°C. Extreme hot and cold temperatures will
damage the upholstery fabric. Some potential results are cold-cracking, brittleness
and upholstery fabric stretching. And, always keep your table away from heaters,
electrical appliances and direct sunlight.
• We recommend cleaning your upholstery fabric to protect it against oil stains and
dirt which will cause cracking and permanent stains over time. Clean your uphol-
stered items when needed using a mild solution of 4:1 diluted non-alcohol cleaner
such as Formula 409
®
, Fantastik
®
, Green Windex
®
or some other non-abrasive
cleaner. For disinfecting purposes you may use Protex, MadaCide, Accell TB,
Virox
®
(Canada) or a diluted 1/100 bleach solution. Dry the table immediately after
cleaning to remove excess cleaning solution. Using citrus based cleaners or other
strong cleaners, such as alcohol, acetone, higher concentrations of bleach or other
products that contain high concentrations of these substances, can shorten the life
of your fabric, or discolor it. Note: Damage caused by cleaners will not be covered
under the warranty.
• Use both ends of the table evenly. Occasionally switch the face rest from one end
of the table to the other to reduce uneven wear.
• Protect your table and accessories with sheets and fleeces. We offer both fitted
sheets and thick fleeces that protect your upholstery fabric against oil stains while
offering comfortable softness to your clients. You can also preserve your face rest
and bolsters with covers and fleeces.
• Use only a mild solution of 4:1 diluted non-alcohol cleaner such as 409
®
, Fantastik
®
or some other non-abrasive cleaner to wipe down the metal and wooden surfaces.
Apply with a damp (not wet) lint-free cloth. Be sure excess liquid does not drip
onto, or into, any of the electrical controls or mechanisms. Be sure that the unit is
unplugged before cleaning these areas. Wipe these areas dry carefully with a lint free
cloth.
• Electronic and/or manual lift mechanisms require no general maintenance or
lubrication. Hydraulic units may require yearly maintenance.
• If the table will be out of use for an extended period of time, the power cord
should be unplugged from the receptacle. To prevent inadvertent damage to the
plug or cord, the cable should be coiled and secured with a wire tie or rubber band.
• The wooden cabinetry of the equipment can be polished with any polish approved
for wooden surfaces. Spray, or pour the polish onto a soft cloth and be careful not
to get it onto other surfaces.
• It is important to visually inspect your table on a quarterly basis to ensure all
components are working properly and safely. Be sure to tighten all bolts to be sure
they are secure. Over time they may work their way loose, leading to an unsafe
condition.
•
• The face rest and table extender should be removed when not in use.
These items should be stored in a cool, dry place.
BASE & CONTROLS
ACCESSORIES
