17
Root-Lever Pro instructions for use, safety and warnings
IMPORTANT: The Root-Lever Pro is designed exclusively as a 1-finger brake lever. This me
-
ans that it should be operated with the index finger alone. If you cannot ensure that you
can operate the brake lever properly, consult a professional bicycle workshop and, if ne-
cessary, have the arrangement of the controls on your bicycle cockpit adjusted.
IMPORTANT: Upon receipt of the Root-Lever Pro, check it for risk of injury, especially due
to possible sharp edges.
IMPORTANT: The Root-Lever Pro may only be mounted with the original assembly accesso-
ries from OAK Components. All installed components must be firmly mounted at all times
and must not come loose, even in the event of vibration.
IMPORTANT: We recommend that the Root-Lever Pro be assembled by qualified personnel
of a bicycle repair shop to ensure proper assembly according to the instructions and notes
in this user manual. After assembly, a functionality test must always be carried out - also
by the professional workshop staff.
IMPORTANT: Mounting the Root-Lever Pro changes the braking behavior of your bike. Test
this new braking behavior at a low speed on a level road and away from traffic. Repeat the
-
se test rides until you are fully familiar with the new braking behavior of your bike. Always
wear a bicycle helmet when using a bicycle.
IMPORTANT: Do not store the Root-Lever Pro in ambient temperatures below -15°C or abo-
ve +55°C. If possible, store all components of the Root-Lever Pro in UV-protected, dry and
not otherwise corrosive locations. Otherwise, the material of the Root-Lever Pro could be
significantly damaged.
IMPORTANT: The brake lever must be serviced regularly. The maintenance intervals vary
depending on the frequency of use and the (weather-related) environmental influences to
which the brake lever is exposed.
IMPORTANT: Check the brake lever and all attachments regularly for damage, wear and
proper adjustment, especially before each ride. Tighten bolts regularly, if necessary to the
required torque.
IMPORTANT: Before each ride, check by pulling and holding the Root-Lever Pro, that the
bite point is clearly defined, does not change and that the brake system can provide suf
-
ficient braking power.
CAUTION: Risk of falling, accident, injury and death if the above instructions are disregarded.
Root-Lever Pro assembly instructions
We recommend that you also use our video instructions for assembly. These can be seen at
www.oakcomponents.com under the heading SERVICE. There, all work steps are explained
in pictures and voice for easier comprehension.
