1
Introduction
Thank you for choosing the CP1 to be a part of
your high performance music listening system.
Each CP1 is handcrafted, using the very latest,
no compromise, cutting edge technology and
componentry. This ensures the best possible
sound reproduction currently available and
guarantees many years of listening enjoyment.
We understand that you are eager to begin
listening; however, please take a few minutes to
read through this guide for useful information
concerning the operation of your new preamplifier.
OAD Ultrafidelity equipment takes a considerable
time to run in before it performs at its best. The
duration varies, but under some conditions the
sound may continue to improve for over a month.
Better and more consistent performance will be
achieved if the system is left switched on for long
periods. It is worth remembering however that
equipment left connected to the mains can be
damaged by lightning.
After reading this manual, if you have any further
questions regarding your preamplifier, contact
your dealer or OAD Ultrafidelity customer service
– they will be happy to help you to make the most
of your new component.
Happy Listening!
Warnings
• To prevent fire, or shock hazard, do not expose
your CP1 to rain or moisture.
•
Do not place objects containing water on top
of this unit.
• This unit contains voltages which can cause
serious injury or death.
• Do not operate with covers removed. Refer
servicing to your authorized OAD Ultrafidelity
dealer or service personnel.
•
A power cord is shipped with your CP1 that
meets the required safety standards. It is
important for both safety and performance
that the standard cable supplied is not
modified.
•
A switch at the rear of the CP1 must be
accessible in case of emergency power
disconnect. The power button on the front
touch display panel of this unit, when off,
does not disconnect all power from this unit.
This unit is in standby mode when not on.
For continued protection against fire hazard,
replace the fuse only with the same type and
rating (see page 8 for fuse information).
• Your hi-fi system, including the CP1, can be
damaged by lightning and should be turned
off and disconnected from the mains when
there is risk of lightning strike.
• We recommend that all connections to the
CP1 are made with either the mains power
cord disconnected or the rear mains switch left
in the ‘0’ (OFF) position. When all connections
are made and checked, move the rear mains
switch to ‘1’ (ON) position.
Ventilation
Due to its highly sophisticated five power supplies,
the CP1 will run slightly warm when not in standby.
You must allow for this in installation, by providing
for free air circulation around the product. Never
block any ventilation openings. Allow at least 50
mm of clearance around these products for proper
ventilation. Electronics should not be subjected to
sources of excessive radiant heat. Excessive heat
can shorten the life of the product.
Packaging
Save all packaging in a dry place away from
fire hazard. Your CP1 is a precision electronic
instrument and should be properly boxed any time
shipment is made. It is very unlikely that you will
have to return your unit to the factory for service,
but if that should prove necessary, the original
packaging will protect your CP1 from unnecessary
damage or delay.
Interconnect Cables
RCA/Phono Interconnect plugs and sockets should
be kept clean and free from corrosion.
The CP1 is fitted with silver plated oxygen free
copper input and output sockets that will tarnish
over time. Tarnished or oxidised silver does not
degrade the quality of contact. This is a distinctive
property of silver plating. If you wish to clean the
connectors, switch off the equipment, pull the
plugs out of their sockets, and push them back in
again. Contact cleaners and “enhancers” should
not be used as the film they deposit may leave a
deposit and degrade the sound.
