O3zone Generator Kit Instructions
6
Installation Instructions
step 6:
Insert the tube connected to the
ozone generator into the air-draw elbow.
Hand-tighten the nut onto the elbow.
step 7:
Unplug the unit from power
supply (on already installed units)
and remove the front cover from the
backplate.
step 8:
Disconnect all connections
to controller board. Take note of which
connections were removed. Remove the
board from the backplate by lifting up
slightly on the upper tab, tilting the top of
the board down, and pulling up and away
from the bottom plastic connectors.
step 9:
Remove board bracket from the
backplate. Lift up on the two upper clips
and pull bracket down and away from the
backplate to remove.
step 10:
Route the 2-pin connection
cable attached to the ozone generator
through the hole in the backplate of the
valve and through the channel above to
keep wiring in place.
Note: Ensure that there is enough wire
length inside the backplate body to reach
the 2-pin connection at the bottom of
the board. Keep wire fitted snugly into
the channel or bracket will not be able to
click back into place.