11
IF THE BELT IS MISALIGNED
If the belt is offset to the left: use the hexagon socket wrench to adjust the
left side of the roller bolt. Make adjustments in 90º increments. Repeat this
action until the left- and right-hand sides are balanced.
If the belt is offset to the right: use hexagon socket wrench to adjust the
right side of the roller bolt. Make adjustments in 90º increments. Repeat this
action until the left- and right-hand sides are balanced.
If the belt is too tight or too loose: use hexagon socket wrench to adjust
the roller bolt until the belt tightness is just right. Make adjustments in 90º
increments on either the right or left side of the roller bolt. Repeat this action
until the left- and right-hand sides are balanced.
E0: Safety key off.
Remedy: Reinsert the safety key.
E1: Speed signal loss.
Remedy: Check if the speed signal cable and motor power cord are
plugged in. Interrupt the power supply for 10 seconds and re-plug in
the power cord to reset the machine.
E2: Overload failure.
Remedy: Check if the treadmill needs to be lubricated.Check if there are
foreign matters between the running belt and the running board resulting
in increased resistance.Interrupt the power supply for 10 seconds and re-
plug in the power cord to reset the machine
E5: Communication signal interruption.
Remedy: Check if the communication cable connector is off or if there is a
break. Adjust or replace the communication cable.
E6: Sampling current abnormalities.
Remedy: Contact our customer service.
E7: Treadmill models selection abnormalities.
Remedy: Contact our customer service.
