![background image](http://html.mh-extra.com/html/o-s-engine/max-46fx-hring-series/max-46fx-hring-series_owners-instruction-manual_719765020.webp)
ADJUSTING CHART
Open the Needle Valve 2 turns from the fully closed position.
Make sure that the Mixture Control Valve is at the factory setting.
A
Start the engine
Warm up the engine
B
C
Observe the mixture condition while "floating" the model
Turn the Mixture
Control Screw
counter-clockwise
Idling OK
Turn the Mixture
Control Screw
clockwise
Lean mixture
Rich mixture
D
E
F
E
Observe the hovering mixture condition
Open the
Needle Valve
(Turn counter-clockwise)
Hovering OK
Lean mixture
Rich mixture
J
H
I
G
Close the
Needle Valve
(Turn clockwise)
Land the model
Idle for approx: 10 seconds, then reopen throttle to
observe transition ("Float" the model)
Turn the Mixture
Control Screw
counter-clockwise
Idling OK
Turn the Mixture
Control Screw
clockwise
Lean mixture
Rich mixture
High Speed Flight
Open the
Needle Valve
(Turn counter-clockwise)
Lean mixture
Rich mixture
L
M
Close the
Needle Valve
(Turn clockwise)
High Speed Flight OK
Fine tuning of hovering mixture
Turn the Needle Valve
2 or 3 clicks counter-
clockwise, or turn the
Mixture Control Screw
10-20 degrees counter-
clockwise. Adjust pitch
control characteristics.
Hovering OK
Response too sensitive
N
Response too slow
Adjustment completed
P Q
O Q
Turn the Needle Valve
2 or 3 clicks clockwise,
or turn the Mixture
Control Screw 10-20
degrees clockwise.
Adjust pitch control
characteristics.
K
19