![background image](http://html.mh-extra.com/html/o-s-engine/max-46fx-hring-series/max-46fx-hring-series_owners-instruction-manual_719765019.webp)
SUBSEQUENT READJUSTMENTS
Once the engine has been run-in and the carburetor
controls properly set up, it should be unnecessary to
alter the mixture settings, except to make minor
adjustments to the Needle Valve occasionally, to take
account of variations in climatic condisitions.
The use of a different fuel, however, particularly one
containing more, or less, nitromethane and / or a
different type or proportion of lubricating oil, is likely to
call for some readjustment of the Needle-Valve.
Remember that, as a safety measure, it is advisable
to increase the Needle Valve opening by an extra
half-turn counter-clockwise, prior to establishing a
new setting. The same applies if the silencer type is
changed. A different silencer may alter the exhaust
pressure applied to the fuel feed and call for a revised
Needle-Valve setting.
The use of a different glowplug, or changes to the
mainrotor and its pitch angles may also require
compensating carburetor readjustments.
CARBURETOR CLEANLINESS
The correct functioning of the carburetor depends on
its small fuel orifices remaining clear.
The minute particles of foreign matter that are present
in any fuel can easily partially obstruct these orifices
and upset mixture strength so that engine
performance becomes erratic and unreliable.
It is recommended that fuel is passed through a filter
when the tank is filled and that a good in-line filter is
installed between the fuel tank and carburettor and,
furthermore, that this filter is frequently cleaned to
remove dirt and lint that accumulates on the filter
screen.
Finally, occasionally remove the needle-valve holder
from the carburetor as shown in Photo and extract
any remaining foreign matter that may have lodged in
the location shown in Photo, right.
Remove this with
an 8mm spanner
Dirt and fbrous matter
mostly accumulate here
18