NZXT. 7
5. Connect the 20-pin ATX power connector from your power
supply (and AUX or +12V connectors if appropriate) to your
motherboard.
Power, Reset Switch Installation
Please refer first to your motherboard manual to find where your
power switch and reset connectors are located. The colors following
each instruction are the color of the wires.
1. Connect the Reset switch (labeled RESET SW) by
connecting to your motherboard RESET connector. Make
sure you always attach the white wire to ground.
(Blue/White)
2. Connect the Power Switch pin (labeled P LED +/-) to the
PWR connector on the motherboard. (Green/White)
3. Connect the HDD LED (labeled H.D.D LED) and HDD LED
connectors to the appropriate headers on your motherboard.
(Red/White, +/-). The hard drive activity is displayed by the
front led under the Power LED. When your hard drive is
active, the blue LED should flash.
All White Pin Connectors correspond to ground.
LCD Temperature Display
Installing Temperature Sensors & Powering the Meter
Begin by connecting the 4 pin Molex connector coming from the
meter to the Power supply.
Remove the clear plastic tube surrounding the probe before installing.
Keep the orange protective that is on the sensor attached.
In order to attach the SENSOR wires, use the tape provided to
attach them to the appropriate locations marked on the wires. The
SYS sensor can be attached to your VGA card or an area near the
rear fan. The HDD sensor is used for the hard drive, and the CPU
meter for the CPU. Please following precautions when attaching the
Summary of Contents for Lexa S
Page 1: ...LEXA User s manual NZXT 1...