WCT1012VLF/WCT1013VLH Consumer MP-A11 (WCT-15W1
CFFPD) V1.0 Wireless Charging Application User’s
Guide, Rev. 1, 05/2019
NXP Semiconductors
21
The macros are defined in
example->wct101xa–>configure-> freemaster_cfg.h
.
d)
gWCT_Params.tDebugConfig.bGeneralDbg = 1;
This variable is in
wct_LibParams.c
.
6.1. Software setup
1.
Plug the USB-UART converting board to SCI connector J4 and connect the console Micro-USB
port to the computer.
2.
Open the Device Manager and check the number of the COM port.
Figure 20. Device Manager
3.
Run the communication program supporting console, such as HyperTerminal or RealTerm.
4.
The following table shows the communication setup.
Table 1.
Port configurations
Port number
Serial port from Device Manager
Baud
19200
Data Bits
8
Stop Bits
1
Parity
None
Hardware Flow Control
None
Display As
ASCII
5.
Open the port or start the communication, depending on the terminal used.