NXP Semiconductors KIT34932SEKEVB, User Manual, Page: 25 / 39

Installing the Software and Setting up the Hardware
KT34FS6407-34FS6408UG User’s Guide Rev. 1.0 8/2015
Freescale Semiconductor, Inc. 25
6.3 Running the GUI
With the KIT34FS6407/8 EVB’s, you are provided with two separate graphical user interfaces (GUI’s) that allow you to
configure registers:
• SPI generator (SPIGen)
• MC3390X_GUI
Both GUI’s are similar in function. You may use either one at your own discretion.
6.3.1 Running SPIGen
To run SPIGen, do the following:
1. Click on the SPIGen icon. This icon appears on your desktop if you elected to create a short-cut during the installation process.
Otherwise, the icon resides in the folder C:Program Files\SPIGen. The generic SPIGen start-up screen appears.
2. From the SPIGen menu bar, click on FILE>Open and select the configuration file “MC33907_8_SPIGEN.spi” (previously
downloaded in
Section 6.1.1 .) Figure 9 shows SPIGen screen with the configuration file installed.
3. In Debug mode, use the SPIGen batch
RST_counter_to_0.sp
i to reset the error counter. FS0B should turn off (LED D12 turned
off).
At this stage, EVB is powered and SPIGen is working. When Normal mode is selected with J17, a valid WD must be sent, otherwise the
device goes into deep fail-safe.
Figure 9. SPIGen Screen