NXP Semiconductors i.MX6UltraLite, Quick Start Manual

Page: 6 / 21

NXP Semiconductors
AN12397
EdgeLock
TM
SE050 Quick start guide with i.MX6UltraLite
AN12397 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
Application note Rev. 1.2 — 17 December 2019
534512 6 / 21
3 Software setup
The software setup consists of:
1. Preparing a micro-SD card with the pre-compiled Linux image for i.MX6UltraLite
board, as described in Section 3.1 .
2. Installing the USB to UART Bridge VCOM driver in your laptop, as described in
Section 3.2 .
3. Installing TeraTerm terminal application, as described in Section 3.3 .
4. Booting the i.MX6UltraLite board, as described in Section 3.4 .
3.1 Micro-SD card preparation
To prepare the micro-sd card with the pre-compiled Linux image that includes the
EdgeLock SE050 Plug & Trust middleware, you need to:
1. Download from
www.nxp.com/se050 the EdgeLock SE050 Plug & Trust middleware
SD Card Image. This image contains the EdgeLock SE050 Plug & Trust middleware
pre-installed on a bootable IMX6UL-EVK SD Card Image.
2. Download and install Win32 Disk Imager software. Win32 Disk Imager is a Windows
open source program to format SD card images. Instead of Win 32 Disk Imager, you
could also use any other software for this operation.
3. Plug your micro-SD card in your laptop.
4. Open Win 32 Disk Imager, (1) select from your file system the pre-compiled Linux
image you downloaded from the website and (2) click the Write button as shown in
Figure 3 .
Figure 3. Micro-SD card preparation with Win32 Disk Imager software
3.2 Drivers
To install the i.MX6UltraLite drivers, follow these steps:
1. Plug the power supply and connect the USB cable to your laptop as shown in
Figure 4 .