NXP Semiconductors
AN12397
EdgeLock
TM
SE050 Quick start guide with i.MX6UltraLite
AN12397
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
Application note
Rev. 1.2 — 17 December 2019
534512
10 / 21
Figure 8. Insert the Micro-SD card
2. Configure the board switches as follows
•
SW601 (Boot Device Select Switch): OFF, ON, OFF, OFF (from 4-1 bit)
•
SW602 (Boot Mode Select Switch): ON, OFF (from 1-2 bit)
3. Make sure the i.MX6UltraLite switches are set as shown in
Figure 9. Configure i.MX6UltraLite board switches
4. Make sure your board is connected to the power supply and to your laptop using a
USB cable and TeraTerm serial port configured (see
5. Turn on the power supply switch to boot up the board. The power supply button is
shown in
