NXP Semiconductors i.MX6UltraLite, Quick Start Manual

Page: 4 / 21

NXP Semiconductors
AN12397
EdgeLock
TM
SE050 Quick start guide with i.MX6UltraLite
AN12397 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
Application note Rev. 1.2 — 17 December 2019
534512 4 / 21
2 Hardware setup
The hardware setup consists of two steps:
1. Mounting the boards, as described in
Section 2.1
2. Configuring OM-SE050ARD jumpers, as described in Section 2.2
2.1 Mounting the boards
1. Connect the OM-SE050ARD board on top of the i.MX6UltraLite board using the
Arduino connectors as shown in Figure 1
Figure 1. Arduino connectors of OM-SE050ARD and i.MX6UltraLite boards
Note : In case the i.MX6UltraLite board does not come with the Arduino headers
assembled by default, they can be easily soldered in the dedicated mounting holes.
2.2 Jumper configuration
1. Make sure the jumper settings in your OM-SE050ARD board are configured as shown
in Figure 2
Figure 2. Jumper configuration for i.MX6UltraLite board