nVent.com | 5
Make sure the bus
wires do not kink,
bunch, or crossover.
1/2 in
(13 mm)
1/2 in
(13 mm)
1 in (25 mm)
8
10
11
9
• Push core sealer onto the heating cable to the
mark made in step 6.
Note: Extra force may be required for larger
cables or at lower temperatures.
• Trim bus wires and braid.
• Remove the guide tubes and dispose of
them in a plastic bag.
• Slip the green/yellow tube onto the braid.
Heat-shrinking is not required.
• Pull heating cable back into stand so 1 in (25 mm) is
exposed as shown. Use cable lubricant if needed.
5/8 in
(15 mm)
6
Tubes
Make sure all strands
go into the tubes.
7
• Mark the jacket
as shown.
• If needed, re-twist and straighten bus wires,
then insert into the guide tubes as shown.
CAUTION: Health Hazard. Wash hands after contact
with sealant in core sealer. Consult material safety
data sheet VEN 0058.
