nVent Hoffman SYSPEND 180-MAX, Installation And Operating Instructions Manual

Page: 7 / 17

Seite 7 von 17
0800000790 / Stand: 3/ Ausgabedatum: 24.04.2018
Rev.B © 2018 Hoffman Enclosures Inc. PH 763 422 2211 • nVent.com/HOFFMAN P/N 89128258 0800000790
Mounting to control enclosure by using narrow adapter
1.
2.
3.
4.
5.
6.
50
100
95
60
40 60
104
24
90
30
50
100
95
60
40 60
104
24
90
30
50
100
95
60
40 60
104
24
90
30
12 x M6 / Ø 6.5
50
100
95
60
40 60
104
24
90
30
50
100
95
60
40 60
104
24
90
30
Mounting to enclosure
�
Press the seal smoothly
� Tube mounting see page 5
� Tube adjustment see page 6
� Lift the enclosure
under the coupling
(support necessary)
� Attach the lock washers
to the screws
�
Fit the screws through
the horizontal section into
the coupling and tighten
them with 6 Nm
At least 4 bolting points must be
used:
- 100 x 60
- 95 x 40
- 60 x 60
Partial representation
of the control enclosure
1. 2.
4x M6 x 16
Tightening torque 6 Nm
�
Mounting to control enclosure by using coupling or elbow coupling
Indication: Mounting of the component “Flange Coupling” is illustrated below
104
24
90
30
�
Adhere the seal to the
underside of the adapter
� Mount the adapter with lock
washers and screws
to the coupling
Partial representation of
the control enclosure
�
Lift the enclosure under the coupling (support necessary)
� Attach the lock washers to the screws
� Fit the screws through the horizontal section into the
coupling and tighten them with 6 Nm
4x M6 x 16
Tightening torque 6 Nm
Only use in conjuction with Flange Couplings and Flange Elbow
Couplings.
4x M6 x 16
Tightening torque 6 Nm