Nu-Link-Gang
Dec. 23, 2019
Page
16
of 37
Rev 1.00
NU
-LINK
-GA
NG
USE
R MA
NU
AL
3.5
Start Programming
3.5.1 Programming
Plug-in a 9V/1A power adapter to the Nu-Link-Gang and press the Power button once as Figure 3-6.
Figure 3-6 Nu-Link-Gang Power On
1.
To start the programming process, press the Start ALL button or the individual Start button
depends on the programming mode switch setting.
2.
The status LEDs on the Nu-Link-Gang and the Nuvoton ICP Gang Adapter will show the
programming results of every unit.
Green light: PASS.
Red light: FAIL.
3.
Change the target chip in the adapter, and repeat section 3.5 process.
3.5.2 LCD Display
Users can switch pages by pressing buttons to show the
individual programming unit’s status and
information. There are four pages:
Page 1: Shows all four units programming status includes programming times and programming
voltage as Figure 3-7. Press Enter button to go to the next page.
Page 2: Programming unit selection page as Figure 3-8. Press Select button to choose the unit.
The choosen unit is high-lighted in yellow. Press Enter button to go to the next page.
