NuvoH2O DPHB, Installation Manual

Page: 6 / 12

nuvowater
.com
877-688-6426
5
Please read all instructions before beginning installation
1 Turn off main water supply line leading to proposed installation site.
2 Attach the Wall Mounting Panel horizontally (softener must hang vertically) to
wall studs with screws provided. It is very important that the panel is attached
to wall studs to allow for system weight and torque needed to adjust the system.
Do not attach bottom right screw at this time.
3 Attach C-Bracket horizontally to Wall Mounting Panel under “Softener” label.
The right C-Bracket screw should go through the Wall Mounting Panel into the
wall stud. Another screw attaches the Wall Mounting Panel to the wall stud
directly above the right C-Bracket screw. See FIG. 1
4 Remove Housing Head from Housing Body by detaching Collar (turn clockwise
or left—use provided Wrench if necessary).
5 Attach Housing Head to the wall by inserting the nipples (not included)
in Housing Head through the side holes in the C-Bracket.
6 Tighten nipples securely into the ports on each side of Housing Head.
WARNING: The inlet and outlet ports are tapered (NPT) and require thread seal
tape or sealant compound to prevent leakage. Be very careful, as over-tightening
the threading can split or break the port. DO NOT OVERTIGHTEN.
These screws must be
securely attached to studs.
INSTALLATION STEPS
For Home System and Studio System
FIG. 1