NUVE NC 300, User Manual

Page: 15 / 35

15
5.7.
CONNECTION TO THE MAINS, WATER AND AIR SUPPLY
5.7.1.
CONNECTION TO THE MAINS

The unit is fed by 3-phased network supply. Please make sure that the supplied mains match
the required power ratings. If not, please provide an extra line to support.

The neutral and grounding cables connecting the socket to the general panelboard shall be
separate lines.

Please make sure that the connection cables between the socket and the panelboard are equal
or greater in cross-section than the power cables of the unit.

The panelboard where the socket is connected shall be fuse protected.
5.7.2.
CONNECTION TO WATER SUPPLY

There exist a supply water inlet line and a waste water discharge line on the unit.

The water from the mains shall be connected to the water inlet of the unit after being treated
by a suitable water softening unit. It shall be always kept in mind that the supply water quality
has a direct effect on the lifetime of the equipment.

The waste water discharge line shall be connected to the general drain system. The piping of
the drain system shall be resistant to a continuous water flow at 65

C and a temporary (2-3
minutes) water flow at 100

C.

A regulator should be used on the lines where the water supply pressure is over 4
bars.
5.7.3.
CONNECTION TO AIR SUPPLY

There is air inlet on the top of the sterilizer.

Dry air line should be connected and it should have 5 to 6 bars of pressure.
6.
OPERATING PRINCIPLES
6.1.
PRIOR TO OPERATION

Turn on the unit by using the On-Off switch on the left side

See that the microprocessor control system is activated.

NUVE logo appears on the screen.

After NUVE logo disappears, Menu page appears.