www.NutrichefKitchen.com
11
3.
After the temperature is adjusted, press the ENTER key to start the work;
4.
The time-delay “ ” function is not available for the descaling program.
After it is completed, the system directly enters the END interface.
6.
End of Work
1.
After the program process is ended, “
END
” appears on the display screen, and
the buzzer will beeps for 10 times, which indicates that the cooking is
completed. Afterwards, you can open the door to take out the food or the
system will automatically exit to the standby status five minutes later.
2.
After the program is over or in the standby state, for a pause or stop in the
midway, the display screen will show the high-temperature prompt icon so
long as the Oven cavity temperature is over 120°F and The centrifugal fan will
delay the working time for 3 minutes.
3.
After the program is completed with the steam function, icon will flash on the
screen, which remind the user to take out the water tank and drain the water in
the evaporator, and then pour away the residual water from water holder.
This icon will flash for 1 minute.
Note:
Removal of residual water and icon display are available only when there are
steam-related functions while evaporating heater is working.
7.
DIY function modes
1
2
3
4
5
6
7
8
9
Steam
Strengthening heating
(Back heater conv top heater pipe + bottom heater pipe)
Top Heater pipe
Top/bottom heater pipe
Hot air convection (top Heater pipe + rear fan)
Back heater convection (Back h rear fan)
High-temperature steaming (steam + Back heater convection)
Back heater conv turning fork
Top Heater pipe + turning fork
Summary of Contents for PKSTMOVN72
Page 20: ......
