Page
ALLURE
®
QS1 SERIES
RANGE HOOD
➙
➙
PREPARE THE HOOD
3 Remove
Wiring Cover
from inside the hood. Set cover and
mounting screw aside.
4 Remove either top or back wiring knockout and install ap-
proved
Electrical Cable Clamp
.
WIRING
COVER
ELECTRICAL
CABLE CLAMP
Ducted Installation - Skip to Step 10.
The following Steps (5 thru 9) are for
NON-DucTeD INSTallaTION ONly.
5 Remove
Light Panel
- held in place with (3) #8 screws
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
6 Remove
Air
Chute
- held in
place with one
(1) screw.
NOTE: Be care
-
ful not to discon-
nect any wires.
8 Rotate baffle. Reinsert
baffle into air chute (as
shown) so that baffle fits
all the way into
into air chute. An audible
“click” will
be heard when
fully installed.
This will direct
air flow through
the non-ducted
slots on top
of hood.
9
Re-install air chute and screw,
re-connect wire harness, and replace light panel.
NOTE: Be careful not to trap wires between Support Fin
and light panel.
AIR CHUTE
SLOTS
7 Remove
Baffle
from air chute.
Tabs
will disen-
gage
from
Slots
.
SUPPORT FIN
TABS
PREPARE THE HOOD
(3) #8 SCREWS
LIGHT
PANEL
(2) #8 SCREWS
➙
➙
BAFFLE
