INST
ALLA
TION,
USE & CARE INSTR
UCTIONS
INST
ALLA
TION
10
PREPARE THE UNIT
A
LL
INSTALLATIONS
1. If present, remove all protective polyfilm from the unit and/
or parts.
2. Remove the grease filters by pushing down on latch tab
and tilting the filters downward (FIG. 14). Set aside the
filters.
3. Disassemble the electrical compartment cover (grey part
in FIG. 15) from inside the unit by removing its retaining
screw. Remove the parts bag behind the cover. Set aside
the parts bag and the cover along with its screw.
FIG. 14
FIG. 16
4. Punch out
one
of the two knock-out holes. Install an
appropriate 7/8” diameter strain relief (not included, grey
part in FIG. 16).
NOTE: The HCK44 cord connection kit (optional) can
be used instead of the house power cable. Refer to the
instruction packed with the HCK44 cord connection kit.
H
ORIZONTAL
EXHAUST
INSTALLATION
ONLY
5. Remove and discard the screw circled in FIG. 17.
NOTE: This screw might be present or not.
6. Unplug the blower cable from its connector on faceplate.
Disassemble the faceplate from the unit by removing its
4 retaining screws (two per side, circled in FIG. 18). Set
aside the faceplate along with its screws.
FIG. 18
FIG. 17
SCREW
FIG. 15
