NUPI Americas, Inc.
- 1511 Superior Way, Houston, TX 77039 -Tel: 281 590 471 - Fax: 832 201 8537
Web site: www.nupiamericas.com - Email:[email protected]
RECOMMENDATIONS FOR THEIR DISPOSAL:
POLYPROPYLENE USED FOR THIS ACCESSORY IS RECYCLABLE: DISPOSE THROUGH AUTHORISED CENTRES. DO
NOT DISPERSE WRAPPING AND PACKAGING OF THE PRODUCT, RECYCLE THROUGH COLLECTION.
FIG.6 MANUAL WELDING PARAMETERS
27NCO11063
8 017175625923
Branch Saddle
FAC SIMILE
WATCH VIDEO INSTRUCTIONS ON OUR
CHANNEL
ELECTROFUSION BRANCH SADDLE INSTALLATION
6. For automatic welding units, always check the welding parameters on the barcode
(SEE FIG.5).
For manual welding please use the time and voltage indicated on the barcode. If the welding
unit does not perform welding time compensation according to ambient temperature, use the
parameters in the label affixed on the bag
(SEE FIG.6).
After completing the welding process, verify that no material has leaked out of the joint between
the pipe and the fitting. Wait for the cooling time as indicated on the fitting barcode before rough
handling.
7. At the end of the cooling time it is possible to start the pressure test with the Pressure Sensor. In
the following table
(TABLE 1)
you find the recommended waiting time in MINUTES before starting
the test.
Table 1. WAITING TIME BEFORE PRESSURE TEST START
ø
P < 87 psi
P < 348 psi
inch.
6 BAR
24 BAR
1”¼ to 2”
cooling time + 20 minutes
cooling time + 30 minutes
2”½ to 12”
cooling time + 20 minutes
cooling time + 60 minutes
8. Proceed now with the perforation of the pipe through a specific cutter (drill bit or hole saw).
NEVER PERFORATE THE PIPE BEFORE COMPLETING THE WELDING PROCESS
9. Connect the service line with the spigot of the outlet, following the installation instructions for that
specific fitting. The underclamp may be removed or left permanently.
• ALWAYS CHECK THE WELDING PARAMETERS.
• CHECK THAT THE DIAMETER OF THE CUTTER IS COMPATIBLE WITH THE INSIDE
DIAMETER OF THE SPIGOT.
• AVOID ANY DAMAGE TO THE SPIGOT DURING THE PERFORATION.
• KEEP AT A SAFE DISTANCE DURING WELDING.
• THE COMPANY IS NOT RESPONSIBLE FOR ANY DAMAGE TO PERSONS OR
PROPERTY IF SAFETY RULES ARE NOT OBSERVED.
981409181103355616120552
27NCOL11063 - 35v - 120s - c.t. 20 min
17350511000236001716990302
04/
02/
2016
27NCOL... :
FITTING CODE
00v:
VOLTAGE
000s:
WELDING TIME
c.t. 00 m:
COOLING TIME
FIG.5 WELDING PARAMETERS
FAC SIMILE
RACC MOD21 USA VER7 NCOL
