48
PIPA urbn instructions
49
PIPA urbn instructions
Using Lap Belt Only
Only install in a forward facing
vehicle seat.
1
- Position child restraint so that child
is facing the rear of the vehicle.
2
- If your vehicle does not have a
shoulder belt, the lap belt only
can be used. Route the belt
across the belt guides, as shown.
3
- Adjust the angle of the child
restraint. A rolled up towel or
foam pool noodle may be used to
adjust the amount of recline.
4
- Angle is correct when blue line
on child restraint (located on
the label on the side of the child
restraint) is level with ground.
5
- Tighten vehicle belt while
pushing child restraint firmly into
vehicle seat. Remove all vehicle
belt slack around belt guides
and feed belt into vehicle belt
retractor.
LOCK
the vehicle belt.
Refer to vehicle owner’s manual
for instructions. If you cannot
lock the vehicle belt, you must
use a locking clip (p.52).
1
4
5
2
See p. 50 for final belt install steps.
3
Summary of Contents for pipa urbn
Page 1: ...IM 000298G...
Page 32: ......
