Nuna Pipa lite, Manual

Page: 16 / 295

EN EN
18 17
PIPA lite Instructions
PIPA lite Instructions
Product Use
Securing Child in Child Restraint
1
Place child in Child Restraint in seated position.
(29)
2
The child should be seated against both the
back and bottom of the seat with no gap
behind the child. DO NOT allow child to slouch.
(30)
Gently guide child’s arms through harness
loops.
3
Place the child into the infant child restraint
and lock the buckle. (31)(32)(33)
4
Tighten harness by pulling on the adjuster
strap. Pull any excess harness webbing through
the buckle towards the child’s shoulder and
pull on the adjuster strap. This may need to be
repeated several times for proper fit. (34)
Verify that the harness is snug around the
child’s shoulders.
Harness straps must be at or just below child’s
shoulders to avoid injury. If harness slots need
to be moved, see Shoulder Belts section.
Make sure that nothing interferes with the
harness. Make sure harness is snug around
child and lays flat. Serious injury or death could
occur to a child that is not secured properly.
If child is not secured properly, child could be
ejected in a sudden stop or crash, resulting in
serious injury or death.
Check that Child is Secure
Buckle is fastened.
Harness straps are not twisted.
Harness is snug – A snug harness cannot be
pinched, and should not allow any slack.
Installation
WARNING
Serious injury or death can occur. The seat alone
cannot be installed in the vehicle. It must be
installed with the base. (35)
Base Installation Using ISOFIX
(Lower Attachments)
1
Unfold the load leg. (36)
2
Fit the ISOFIX guides with the ISOFIX anchor
points. (37) The ISOFIX guides can protect the
surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
3
Rotate the ISOFIX connectors 180 degrees
until they are pointing in the direction of the
ISOFIX guides. (38)
4
Line up the ISOFIX connectors with the ISOFIX
guides, and then click both ISOFIX connectors
into the ISOFIX anchor points. (39)