25
24
IN
S
TA
LL
A
TION
IN
S
TA
LL
A
TION
If the car is fitted with a
child restraint anchorage
point:
Locate the anchorage point
behind the rear seating
position (consult the vehicle
owners handbook for loca-
tion of the anchorage point).
Remove the thread plug from
the parcel shelf/floor/roof
and install the attachment
bolt as shown opposite.
CAUTION:
DO NOT OVERTIGHTEN
THE ATTACHMENT BOLT.
MAXIMUM TORQUE 20Nm.
Attachment
Bolt
Lock
Washer
Spacers (if
required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle
Trim
FRONT OF VEHICLE
WARNING
CHILD RESTRAINTS MUST NOT BE ATTACHED
TO UNSOUND METAL OR WOOD OR SYNTHETIC
STRUCTURES. WHEN DRILLING THE 9 MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST
BE PROTECTED FROM SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS
DESCRIBED ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
If the car is not fitted with
a child restraint anchorage
point:
For sedans only
- drill a 9
mm hole in the parcel shelf
on the centre line of the
seating position as shown
on page 23.
Install the anchor bolt as
shown opposite.
It is recommended that this
installation be carried out by
a child restraint fitting station
or licenced motor mechanic.
For vehicles other than se-
dans
- In Australia, consult
your nearest child restraint
fitting station or traffic
authority for vehicle inspec-
tion to find the best, correct
position for the placement of
the anchorage point, and for
the correct attachment bolt
length and use of spacers.
In New Zealand, consult the
agent for the vehicle.
Attachment
Bolt
Spacers
(if required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle Trim
FRONT OF VEHICLE
Lock
Washer
Nut
Reinforcing
Washer
Installation — Tether Anchorage
Installation — Tether Anchorage