39/46
1
2
3
6.2.2 Wiring diagramm
Image 30
6.2.3 Notes on connection
Step 1:
The signal adapter must be connected to PWT 101 at input X1�
Step 2:
The NUMERIK JENA measuring device must be connected to the signal adapter�
Step 3:
Then you can start via „Automatic diagnosis“ or „Manual diagnosis“ in the main menu�
Note:
• Make sure to follow the right sequence of the mounting steps during mounting�
• Do not overtighten screws
• Do not exert mechanical stress on the plug connections
Note: Incorrect power supply range and incorrect wiring / pin assignment can
cause damage to the device and the measuring instrument.
Pay attention to the power supply range of the connected encoder!!
Connect or disconnect the adapter between measuring device and device only
when the device is disconnected from the power supply.
