
16
11.
Auto-Loop / Beat-Jump Buttons:
These eight buttons correspond to the deck's eight
pads while in Auto-Loop Mode. In that mode, press one of the pads to trigger an auto-
loop of the corresponding length. See
Top Panel > Pad Mode Controls > Auto / Roll
to
learn more.
When Beat Jump is activated, the bottom four pads are used for Beat Jump controls. See
Top Panel > Navigation Controls > Beat Jump
to learn more.
12.
Effect Name:
In Multi-FX Mode, the view will show three effects with one parameter
knob each.
In Single-FX Mode, the view will show one effect name with three parameter knobs.
To switch between Single-FX Mode and Multi-FX Mode, press and hold
Shift
and press
the
Beat
button.
To move to the next effect (in either mode), press and hold
Shift
and then press the
FX
Button
under the effect name. Alternatively, press and hold
Shift
and then turn the
FX
Knob
under the effect name to move quickly through the list.
13.
Effect Parameter:
In Multi-FX Mode, the view will show three effects with one parameter
knob each, which corresponds to the main parameter of that effect. To adjust each
effect, turn the
FX Knob
below it.
In Single-FX Mode, the view will show one effect name with three parameter knobs. To
adjust each parameter, turn the
FX Knob
below it.
To switch between Single-FX Mode and Multi-FX Mode, press and hold
Shift
and press
the
Beat
button.
14.
Effect Beats Multiplier:
This number determines the timing or rate of the effects, based
on the BPM.