3
REAR CONNECTIONS
1.
Channel Inputs: Unbalanced RCA jacks
for connecting external sources. The
Phono/Line input is selected using the
toggle switch on the front panel.
Turntables, HiFi VCRs, cassette and reel-
to-reel tape decks, DAT machines, CD
players, laser discs, tuners, even
synthesizers or other mixing consoles
can be connected using these jacks.
NOTE: Plug mono audio sources into
both left and right inputs using a “Y”
cable connector.
2.
GND: This screw connector should be
used to connect any turntables or other
devices that need to be grounded.
3.
Input Selector Switch: Use this to
allow either line level or phono level
equipment to be plugged into your
channel inputs. When Phono input is
selected, your signal is fed directly to the
high-quality RIAA phono pre-amplifiers.
Use this position only for turntables. Line
level sources will overload the sensitive
phono pre-amps and will sound very
bad, so always be sure to toggle the
line/phono switch over to line before
connection of line sources.
4.
Video OUTPUT: There are two outputs
that are connected to television monitors
to output karaoke text.
5.
Master Output (RCA): This output is
for connecting an external monitoring
device such as a PA system, powered
monitors, or a home stereo. The level of
the master stereo output signal is
controlled by the master fader.
6.
Stereo Balanced Master Outputs
(XLR): low-impedance XLR type
connectors controlled by the Master
fader.
7.
Microphone 2 and 3 Input: Plug in
your ¼” microphones into 2 and 3.
These inputs have effects available on
the face panel.
8.
AC In: This mix station is designed to
work with the power supply cord that
comes with the unit. While the power is
switched off, plug the power supply into
the mix station first, then plug it into the
outlet.
9.
Power Switch: Use this switch to turn
on the mix station after all input devices
are already connected to prevent
damage to your equipment. Turn the
station on before you turn on amplifiers
and turn off amplifiers before you turn
off the mix station.
10.
NTSC/PAL Switch: Selects the video
output between NTSC and PAL video
modes. NTSC is used in the United
States, while PAL is used in much of
Europe.
Summary of Contents for KMX01
Page 23: ...23...