53
the device fails to detect a sound from your
baby for more than 20 seconds.
Note:
At VOX level 5, the device is set to
continuous transmission. There is no Eco-
Mode at this level.
The connection indicator
flashes green
while Eco-Mode is active.
The screen will be white, as video
transmission is deactivated.
The appropriate symbol is shown
in the status bar in place of the
symbol that indicates the received
signal strength.
Deactivating Eco-Mode
Eco-Mode is deactivated when:
• your baby makes a sound that exceeds
your set sound limit (VOX level)
• you increase the VOX level setting to 5
(continuous transmission) (see
"6.8 Setting the VOX sensitivity level" on
page 62)
• you use the talk-back function (see
"6.15 Talk-back function" on page 72)
• you activate the lullabies (see
Note:
If VOX level 1 is set and the
lullabies are played at the lowest volume
setting, Eco-Mode can still be activated,
as the lullabies will not exceed the set
sound limit.
• you switch the nightlight on (see
• you briefly press the On/Off button
When Eco-Mode is deactivated:
• the connection indicator
will show a
steady green light
• video and sound transmission will be
active again
• the status bar will show the received
signal strength symbol again instead of
the Eco-Mode symbol
Full-Eco-Control
The Full-Eco-Control function maintains the
connection between the parent unit and the
baby unit at all times, so that sounds, video,
and warnings (e.g. temperature alarm) can
be transmitted by the baby unit when
necessary.
The Full-Eco-Control function guarantees
that you and your baby are always
connected. Even when ECO mode is
activated, the baby unit will perform a link
check every 30 seconds to make sure that
the parent unit is still nearby and maintain
the connection between the two units.
If you are out of range at any time, the
parent unit will indicate this by changing the
colour of LED
to red and beeping.
A red warning symbol will appear on
the screen.
Note:
Check the range of your baby monitor
before using it.
5. Operating the baby unit
5.1 Switching the baby unit on
and off
The baby unit
will switch on automatically
as soon as you have connected the mains
adapter and plugged it into the power
supply. You can then switch the baby unit
off and back on as required.
• To switch the baby unit
on or off, press
until the
power LED
lights up or switches off.
5.2 Indicator LEDs
• The Power LED
lights up green while
the baby unit is switched on.
• The VOX LED
green when there is an established
connection between it and the parent unit.
• The VOX LED
will not be lit while the
baby unit
is switched to Eco-Mode or if
it was not possible to set up a connection
to the parent unit.
Summary of Contents for Eco Control Video Display 550VD
Page 3: ...12 2 13 8 10 14 31 19 21 20 33 34 28 32 29 24 18 16 1 17 5 7 15 11 6 3 23 25 26 27 30 9 22 4 ...
Page 4: ......
Page 237: ......
