NUK Eco Control Video Display 550VD, Operating Instructions Manual

Page: 56 / 238

54
5.3 Setting the volume
We recommend switching the lullabies on
(see "5.4 Playing the lullabies" on page 54)
for setting the volume on the baby unit, as
playing them can help you decide which of
the five possible volume settings is best
suited to your purpose.
1. To activate the lullabies on the baby unit
1 , press the button Lullabies on/off 12 .
Note: The lullabies can also be activated
from the parent unit 17 (see
"6.11 Lullabies" on page 67).
2. Use the VOL +/- buttons 11 to set the
volume at which baby will hear the
lullabies or your voice.
5.4 Playing the lullabies
This NUK babyphone has four especially
composed lullabies and soothing natural
sounds to help you soothe your baby and
lull it to sleep.
1. To activate the lullabies on the baby unit
1 ,
press the Lullabies on/off button 12 .
Note: The lullabies can also be activated
from the parent unit 17 (see
"6.11 Lullabies" on page 67).
2. You can change the current song by
holding down the Lullabies on/off
button 12 . This automatically goes on to
the next song.
Note: If the timer function has been
activated on the parent unit (see "Activating
the timer“ on page 69), and you change
from one lullaby to the next directly on the
baby unit, the timer will be restarted. If the
timer function has not been activated, the
lullaby will continue to be played repeatedly
until switched off by you on the parent unit
or the baby unit (see “Switching the lullabies
off“ on page 68).
5.5 Nightlight
The baby unit’s soft nightlight can help your
baby to get its bearings in the dark room,
which it may find soothing. The nightlight
remains on until it is switched off by you or
the timer function (see "6.5 Switching the
nightlight on and off" on page 57).
1. You can switch the nightlight on or off on
the baby unit by briefly pressing the
button
Nightlight on/off 13 .
Or
2. You can switch the nightlight on and off on
the parent unit (see "6.5 Switching the
nightlight on and off" on page 57).
5.6 Registering remote units
on the parent unit
The parent unit and the baby unit included
in the same delivery package will normally
connect automatically once they are
switched on.
However, you can operate up to 4 baby
units (cameras) connected to the same
parent unit. Additional baby units can be
obtained from www.nuk.de, for example.
To add one or more cameras/baby units,
follow the instructions in section
"6.7 Adding and selecting a camera, and
activating patrol mode" on page 58.
5.7 Measuring the room
temperature
The baby unit has an integrated temperature
sensor which is not visible from the outside.
This sensor measures the temperature in
around the baby unit, which is displayed
and continually updated on the parent
monitor.
Notes: To avoid affecting the temperature
measurement:
– do not cover the baby unit
– do not place the baby unit near a
heater or cold surfaces
– do not place the baby unit in direct
sunlight.