Nugen 7000XTR, Service Manual

Page: 13 / 44

Page 13
Master Programming Mode
When the Master Programming Mode is entered, parameters can be set to make the timer function as needed.
NOTE: Depending on current option settings, some displays cannot be viewed or set.
Entering Master Programming Mode:
1. Press and hold the Shift and Up buttons for 5 seconds.
OR
2. Set the time of day display to 12:01 PM or 12:01HR (See the User Programming section to .
learn how to set Time of Day). Then go to the main display screen, press the Up and Down .
buttons at the same time for 5 seconds.
Exiting Master Programming Mode:
1. Press the Extra Cycle button once per display until all are viewed. Master Programming Mode is .
exited and the normal display screen appears.
2. To exit the Master Programming Mode without saving, press the Diagnostic button.
. NOTE: If no keypad activity is made for 5 minutes while in the Master Programming Mode, or if
there is a power failure, no changes will be made, and the unit will go back to the main display
screen.
Resets:
.
Soft Reset: Press and hold the Up and Down buttons for 25 seconds until 12:00PM (or 12:00HR) .
appears. This resets all parameters except for the flow meter totalizer volume. .
. Master Reset: Hold the Extra Cycle button while powering up the unit. This resets all of the .
parameters in the unit. Check and verify the choices selected in Master Programming Mode.
System Type
This program step selects the system type. .
— Press the Up or Down buttons to adjust this value. .
— Press the Extra Cycle button. .
.
.
.
.
Valve Type
This program step selects the valve type. .
— Press the Up or Down buttons to adjust this value. .
— Press the Extra Cycle button. .
.
.
.
.
1.
2.
CAUTION: Before entering Master Programming, please contact your local professional water dealer.