These settings allow to select the mode of operation. If you
want to configure each loudspeaker individually, select
single
.
You now have complete access to all configuration options.
The standby power consumption in
single
mode is < 1 watt.
If you want use your nuPros as a stereo pair using a wired a
connection, select pair on both loudspeakers. This is the default
setting. The standby power consumption in
pair
mode is < 1 watt.
The loudspeakers then configure themselves automatically as
slave and master. Both speakers can be operated from the mas-
ter speaker box.
For wireless operation, select
wls slave
on the slave speaker
box and
wls master
on the master speaker box and confirm
your selection with the key.
The loudspeakers now connect (display: connecting) and
confirm the connection (display: connected). Standby power
consumption is < 2 watts in
wireless
mode.
Note:
In the single mode the link output will output the
input signal in the SPDIF format. This signal is not affected
by the volume control. This enables multiple nuPros to be
daisy-chained.
Use the
and
keys to choose between
pair
and
reset
.
Pressing the key when
pair
is shown in the display starts the
pairing procedure and the loudspeaker can now be paired with
a compatible smartphone, tablet or computer. Pairing mode is
active for 60 seconds.
Pressing the key when
reset
is shown in the display delete all
paired devices from the memory of the nuPro loudspeaker. This
can be necessary if more than 8 devices are stored.
Here you can specify whether the loudspeaker should play back
the left (
left ch
) or right (
right ch
) channel.
If you want the loudspeaker to play back a summed mono
signal, select mono in the menu.
When using the loudspeaker in master/slave mode, the slave
speaker will be configured automatically.
Here you can set the low-cut frequency of the nuPro. This is
particularly useful when used in conjunction with a subwoofer.
To set the cut-off frequency, select system hp by pressing .
You can now change the 10 Hz default value in 1 Hz steps by
pressing the
and
keys.
The subwoofer output only outputs low frequency sound.
The desired upper cut-off frequency can be set under this
menu item. To do this, use the
and
keys.
Note:
The SUB out signal is a summed mono signal.
The input sensitivity for the analogue AUX and XLR inputs can
be set to either 0 dB or +6 dB using the
and
keys.
>
O
<
>
<
channel
>
O
<
>
<
pair
>
O
<
>
<
reset
>
O
<
>
<
left ch
>
O
<
>
<
advanced
>
O
<
>
<
system-hp
>
O
<
>
<
subwoofer
>
O
<
>
<
analog gain
>
O
<
>
<
hpf
10Hz
>
O
<
>
<
lpf
140Hz
>
O
<
>
<
gain
0dB
Continued on page 12
MAIN MENU
SUB-MENUS
>
O
<
>
<
wls master
>
O
<
>
<
wls slave
>
O
<
>
<
single
>
O
<
>
<
pair
>
O
<
>
<
setup
>
O
<
>
<
bluetooth
EN 12/2019 · E1
2
·
nuPro X-3000
11
